Cart 0

How to Make a Rope Shelf

 

This shelf is simply a scaffold plank threaded with two lengths of rope that are knotted and frayed. Rustic metal handles have been used to attach the shelf to the wall and covered with rope knotted like a plait.

 

You’ll need some natural-looking 3-strand polyester rope – at least 3 metres for each side. If you can’t get hold of a new or old scaffold plank, a chunky wooden board will do. Cut the board 100cm in length

Drill a hole at both ends of the front, 4cm from the front edge, with a 10ml drill bit

Screw two standard door hinges on the back of the plank, 3cm from the outside edge at both ends. These will be hidden

Cut your rope into two lengths and make a stopper knot in each. You need more rope than you might think for this knot, so measure approximately two feet from the end

Hold the rope between your index finger and thumb, take it around the tip of your index finger then go backwards over the rope towards the hand and turn five times

With your other hand slide the rope coil off your finger and with your other hand insert the short end back through all the loops

Insert the short ends through the coil

Gently pull both ends and work the coil as tight and evenly as possible

Decide on the length of your ‘tail’ and cut – you want it to unravel and fray

Now place your wooden plank against wall and use a spirit level to make it level. Open the hinges out, mark and attach the plank to the wall. Use appropriate fixing for the wall – use a wood screw for a timber wall or wall plug/screw anchor with masonry drill for cement

Once the shelf is horizontal and held in place, pull your rope up through the holes you made, using your knots as stoppers

To find the best position and angle for the handles that will hold your shelf horizontally, place the rope against the wall under tension and mark with a pencil. This mark gives you the bottom position of the handle

Screw your handles to the wall

Wrap the handles with the rope in a series of reversed half hitches

Pull everything tight and decide where you want to cut the rope at the top

Wrap some tape – any tape – two times around the rope and then cut with a knife through the centre

Seal the end with the tape still in place using a lighter. As it’s molten plastic the end of the rope will be extremely hot so do not touch until cool, then remove the tape. The end will now be sealed and won’t unravel

 

Find more ore inspiring tips and techniques here!

https://www.anniesloan.com/techniques